An exemple of scanner

Which camera works? Where can you buy an adequate laser? And more...

An exemple of scanner

Postby santo » Wed Jun 10, 2009 2:07 pm

Hello,

I address the bench of scannage to you which I assembled. It
comprises a red laser not focusable (of the shop DAVID) pulled by an
engine PAP of 84 steps and a reduction of 1/125ém. That thus gets a
minimum displacement of 125*84/360=29,16 per degrees, that is to say
for a sweeping of 30°, 875 lines, I work in 800*600 and that is thus
largely sufficient. The engine is controlled by a chart " Easy step "
the software is the version pro of DAVID, the computer is a centrino
1,6 GHz.

I you joint a certain number of photograph in order to better
apprehend the assembly. The pink small rule that one can see with the
top of the laser is used as reference at the time of the scan without
background. The parameters all of scan are with the green, except the
width beam which is yellow to 3,5.

By hoping that these indications can render service, cordial
greetings.

Pierre
PH3.jpg
Attachments
PH4.jpg
PH5.jpg
santo
 
Posts: 55
Joined: Fri May 29, 2009 8:25 am

Re: An exemple of scanner

Postby santo » Wed Jun 10, 2009 2:24 pm

To supplement the explanations of the precedent post, I address an
example of scan to you and the visualization 3D which accompanies it
(carried out with a patern)
cordially
Attachments
PH1.jpg
PH2.jpg
space representation
David Laserscaner version 2.4.5 avec licence, Centrino dual core 2 GHz, 4 GOct mémoire, non focusable laser rouge, moteur pas à pas + réduction de 1 / 470.
  Pierre
santo
 
Posts: 55
Joined: Fri May 29, 2009 8:25 am

Re: An exemple of scanner

Postby Synapse3D » Wed Jun 10, 2009 4:50 pm

Hi Santo!

Nice work with this setup. Just received my stepper motors and pc control board this afternoon. So, i have to mount it, test it. Will post my setup as it works!... :wink:

Best regards,

Ben.
Dell T7400 workstation Dual Xeon Quad cores, 16GB RAM, QuadroFX 4600, Dual Dell 23 inches displays, XP Pro x64, David Laser starterkit 2.3.
http://www.ima-solutions.fr
User avatar
Synapse3D
 
Posts: 24
Joined: Fri May 08, 2009 10:42 am
Location: Toulouse, France


Return to Laser and Camera Hardware

Who is online

Users browsing this forum: No registered users and 3 guests