I have a project with 54 "quality" scans of a fairly complex engine castings. I've cleaned them up, aligned etc. but I can't seem to fuse them. If I try to fuse 20 or more scans David starts then the red progress bar goes away and nothing happens. It still says that it's fusing the scans at the bottom left of the window but it isn't working and the other buttons and menus are selectable again. Has anyone had this problem? I'm running this on a dell workstation running win 7 64 with 8gig of ram. I'm suspecting a memory problem but I've fused meshes with a larger number of scans than this before. Any one have any ideas?
µ