Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Fabscan hardware to David scans

Questions, problems, comments and tips regarding the 3d scanning process.

Fabscan hardware to David scans

Postby hyppyayo » Wed Dec 18, 2013 4:30 pm

Hello Everybody,
i get a fabscan kit with fabshield, and i would like to use this hardware to scan with David Software. The fabscan results are so bad, but i think it's a good idea to use this hardware for David.

my problem is the arduino sketch, how could i interface to control the 2 motors (turntable andl laser) (the shield uses pololu)?

in attach there is the fabscan sketch.

There is an Angel who helps me?
Attachments
FabScanArduinoFirmware.rar
(1.68 KiB) Downloaded 198 times
Windows 7 pc
Acer P1165 projector + Logitech C920 cam
Black & Decker Laser Line Level
hyppyayo
 
Posts: 41
Joined: Fri Oct 26, 2012 3:02 pm
Location: Riccione (italy)

Re: Fabscan hardware to David scans

Postby MagWeb » Wed Dec 18, 2013 6:15 pm

Hi,

besides programming the arduino - this should be doable:
AFAIK FabScan is a turntable scanner. This isn't DAVIDs concept. You might use some components as cam, laser, stepper and controller but you might have to construct a different setup. You might also need aditional parts (e.g. a gearbox to get better resolution for the laser stepper) . Are you aware of this?
MagWeb
Moderator
 
Posts: 2499
Joined: Wed Jul 18, 2007 8:48 pm

Re: Fabscan hardware to David scans

Postby hyppyayo » Tue Feb 25, 2014 5:52 pm

i'm interest too to convert fabscan to use with david.
Windows 7 pc
Acer P1165 projector + Logitech C920 cam
Black & Decker Laser Line Level
hyppyayo
 
Posts: 41
Joined: Fri Oct 26, 2012 3:02 pm
Location: Riccione (italy)

Re: Fabscan hardware to David scans

Postby hyppyayo » Tue Mar 04, 2014 6:28 pm

my idea is to use the fabscan shield to drive motors. I need only the arduino code for automatic scan
Windows 7 pc
Acer P1165 projector + Logitech C920 cam
Black & Decker Laser Line Level
hyppyayo
 
Posts: 41
Joined: Fri Oct 26, 2012 3:02 pm
Location: Riccione (italy)


Return to 3D Laser Scanning

Who is online

Users browsing this forum: No registered users and 1 guest

cron