Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Hardware assembly for lasser scanner

Which camera works? Where can you buy an adequate laser? And more...

Hardware assembly for lasser scanner

Postby benoy » Tue Sep 27, 2011 3:44 am

Hi, :D :D
I am a non engineer with an interest in 3d scanning. I own and scan with David scanner since 3 years. Now I would like to have a a motorized assembly for scanning. Is there any one who make them so that I can buy. That is a laser drive, motorized object turn table which is synchronized with the laser drive and other software settings

Thank you :roll: :roll: :roll: :roll:

Posts: 143
Joined: Wed Feb 11, 2009 8:03 pm
Location: India

Return to Laser and Camera Hardware

Who is online

Users browsing this forum: No registered users and 1 guest