Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

the David Cam

the David Cam

Postby Christian.Q » Wed Apr 24, 2013 9:21 am


I need to buy a Camera for my scanner, and i thought to buy the DAVID-CAM-3-M.

For other used, I want to know if this camera is conciderated as a webcam by the PC or not.

With regards,

Posts: 5
Joined: Mon Mar 18, 2013 4:39 pm

Re: the David Cam

Postby Alyx » Wed Apr 24, 2013 1:02 pm

addition to this question, will it work with Flexscan3D? Who could test that?

Thank you!
Acer i7 3610qm GF GT650M 2gb 16gb ram
Posts: 64
Joined: Sun Oct 28, 2012 11:39 am

Re: the David Cam

Postby hal » Mon Apr 29, 2013 3:43 pm

@ Christian: I have similar camera, and because it works with same drivers that so many software use, it works also as webcam, but with higher resolution. Tested succesfully with Skype, Microsoft MovieMaker, QQ.

User avatar
Posts: 1527
Joined: Thu Mar 01, 2007 4:08 pm
Location: Cavaria con Premezzo (VA), Italy.

Re: the David Cam

Postby Christian.Q » Fri May 03, 2013 1:55 pm

Thx Mattia :D
Posts: 5
Joined: Mon Mar 18, 2013 4:39 pm

Re: the David Cam

Postby spark » Thu Dec 10, 2015 12:41 pm

Hi Alyx,
do you got confirmed informations if the david-cam-3-m also works with flexscan3d?
Compatibility up to which version?

If i got it right- flexscan started in the the early phase supporting dslr and videocameras
in the current version 3.2 the support is reduced to pt. Grey camera.
uEye camera support was until 3.1

regards, Spark
Posts: 12
Joined: Sat Dec 05, 2015 11:16 pm

Re: the David Cam

Postby bartekplechoc » Wed Feb 03, 2016 9:31 pm

Hi where I can find this Flexscan3d software ver 3.1 eny source?

Ragrds bart
Posts: 1
Joined: Thu Jan 28, 2016 7:45 pm

Return to Hardware

Who is online

Users browsing this forum: No registered users and 1 guest