Hi there
Because I'm working around a study on 3D scanners and I'm probably going to use DAVID as software tool to realise this I've been asked to do some research how the software works.
I was thinking about the calibration, calculations, ...
That's why I'd ask the admins if it's maybe possible to have maybe a document or something where this is explained. I've been looking around but I couldn't find anything yet.
Grtz Ruts
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
Calculations behind DAVID
3 posts
• Page 1 of 1
Calculations behind DAVID
by RutsT » Wed Mar 12, 2014 3:47 pm
- RutsT
- Posts: 4
- Joined: Tue Mar 11, 2014 1:41 pm
Re: Calculations behind DAVID
by WalterMo » Wed Mar 12, 2014 6:13 pm
-
WalterMo - Moderator
- Posts: 2363
- Joined: Mon Apr 02, 2007 6:52 pm
- Location: Braunschweig, Germany
Re: Calculations behind DAVID
by RutsT » Wed Mar 12, 2014 7:04 pm
Thank you Walter. You helped me a lot.
- RutsT
- Posts: 4
- Joined: Tue Mar 11, 2014 1:41 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest