Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

no crash

no crash

Postby erniej » Thu Mar 27, 2008 4:06 am

I spent two hours trying to get this one to crash. I think I was using the unfused object as the starting base for my point-to-point alignment.
So I may have been double clicking "non-glued" =0 then double clicking "glued" =0 then 1 - 1, 2 - 2 but in the wrong order. The other thing I did was to save the fused objects with a .ply extension and then re-loading them.
I am going to try a couple more "wrong" not fused to fused poini to point to see if I get any crashes.

erniej
Attachments
ernie_04 Mar. 26 22.58.jpg
erniej
 
Posts: 146
Joined: Sat Dec 22, 2007 7:51 pm

Return to Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron