Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

ArtCAM compatibility

ArtCAM compatibility

Postby brojo19 » Sat May 26, 2012 9:57 am

Hi,

I have ArtCAM and I make all models there but I want to buy DAVID 3, is DAVID 3 compatible with ArtCAM ? Can I open DAVID´s 3D model in ArtCAM ?

On DAVID´s website writes that it exports in .OBJ, .STL, and .PLY but I can´t see any of these in ArtCAM, does it works ?

Thanks
brojo19
 
Posts: 2
Joined: Sat May 26, 2012 9:51 am

Re: ArtCAM compatibility

Postby WalterMo » Sat May 26, 2012 10:41 am

Hi,
I just had a look at ArtCAM and could see that OBJ and STL files can be handled:
http://www.artcam.com/faq.html

Simply test it and download the ready scanned DAVID-Angel as OBJ or STL from here:
http://www.david-laserscanner.com/?section=Downloads


Walter
User avatar
WalterMo
Moderator
 
Posts: 2363
Joined: Mon Apr 02, 2007 6:52 pm
Location: Braunschweig, Germany

Re: ArtCAM compatibility

Postby Khalid Khattak » Sat May 26, 2012 3:23 pm

As Walter says and by my experience Artcam accept the 3d files from David.
PC: Dell Inspiron i3, 2.27GHz,4GB RAM,64 bit windows 7
CAMERA:
David CCD Mono USB
LASER:
David 5mW Green line laser
PROJECTOR:
3D LED Mini Projector 250lumens, Native 1024x600
[b]http://free3dscans.blogspot.com/
Khalid Khattak
 
Posts: 942
Joined: Thu Apr 23, 2009 1:30 pm
Location: Pakistan

Re: ArtCAM compatibility

Postby brojo19 » Fri Jun 08, 2012 5:59 pm

thanks a lot :)
brojo19
 
Posts: 2
Joined: Sat May 26, 2012 9:51 am


Return to Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron