Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

meshlab commands

meshlab commands

Postby erniej » Thu Jan 24, 2008 2:53 pm

Hi

I am new to MeshLab and I was wondering which of the commands are used to reduce the number of polygons in a David fused oblect. Or, make it a smaller sized file.

thanks

ebj
erniej
 
Posts: 146
Joined: Sat Dec 22, 2007 7:51 pm

Postby MagWeb » Thu Jan 24, 2008 4:22 pm

Hi,

Filters/Quadric Edge Collapse Decimation

Gunter
MagWeb
Moderator
 
Posts: 2499
Joined: Wed Jul 18, 2007 8:48 pm

thanks MagWeb

Postby erniej » Thu Jan 24, 2008 8:52 pm

Thank you MagWeb,

You always bail me out.

ebj
erniej
 
Posts: 146
Joined: Sat Dec 22, 2007 7:51 pm


Return to Software

Who is online

Users browsing this forum: No registered users and 2 guests

cron