Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

similar shapefusion software

similar shapefusion software

Postby buzzy » Fri Dec 21, 2007 5:11 pm

Hi all,

I have Rhino 3D 4.0, 3Ds Max 8, Inventor 2008 and Solidworks 2005.
Can any of this software do the same thing as Shapefusion in regard to stiching different views using Davis_Laserscanner?


Posts: 3
Joined: Fri Dec 21, 2007 3:23 pm

Postby leo » Fri Dec 21, 2007 8:47 pm

No, you can not do the same thing as ShapeFusion as the register command is not available in this products.

Buy shapefusion. It is really very cheap, very god and worth the money. I have tried to do in Rhino before shapefusion was released and I don’t recommend. It is a lot of tries to align the scans correctly and difficult to get smooth transition between them.

Posts: 48
Joined: Fri Feb 09, 2007 11:50 pm
Location: Sweden


Postby buzzy » Fri Dec 21, 2007 9:57 pm

Thank you for your advice and timely response.

After I use Shapeform 3Ds Max could do some nice rendering.

I ordered Shapefusion last night. I am dying to try it out. I am waiting for my laser pointer to arrive also.

About how long does it take to receive Shapeform after someone places an order?


Posts: 3
Joined: Fri Dec 21, 2007 3:23 pm

Return to Software

Who is online

Users browsing this forum: No registered users and 1 guest