Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

David-Camera-3.1M can not be identified!

Anything that doesn't fit the other topics should go here.

David-Camera-3.1M can not be identified!

Postby alioguler » Sun Aug 07, 2016 10:36 pm

Hello there,
Microsoft Windows 10, 1607 update installed on my system. "David-Camera-3.1M" Although defined in the system, can not be identified by David 3D Scanner Pro and The camera is not selected, and before scanning, scan the calibration gives the structure of the warning message.
What could be the reason for this. "David-Camera-3.1M" drivers have been identified to date and the correct camera driver version
screenshots on the subject is attached.
I would appreciate if you could help in the solution. This is David 3D SLS-2 update with new windows, to use my system, what should I do?
Thank you for your support.
I wish you good work.
Best regards.

OS: Windows 10 x64 v1607 (OS Build 14393.10)

Ali Osman Güler
David 3D v4.5.2
David 3D V5.0.3
David-Camera-3.1M Driver
Posts: 3
Joined: Sun Jan 18, 2015 11:07 pm

Re: David-Camera-3.1M can not be identified!

Postby drndadoo » Tue Aug 09, 2016 12:32 pm

Hi Ali Osman,

have you tried to reconnect the cam (unplug, plug in), test the other USB ports please, try to ser power plan in windows to high performance.
If that doesn't help please go to help menu and click on "create support request" and send it to DAVID. Email address is sent to you in private message.
DAVID Support
Posts: 194
Joined: Tue Mar 24, 2015 3:09 pm

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest