Dear DAVID Community,

As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.

To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums

Snuffbox scanned whith David

Anything that doesn't fit the other topics should go here.

Snuffbox scanned whith David

Postby MarcelB » Fri Nov 27, 2015 7:48 pm

Original lezard, 30 cm in one piece pottery, was scanned whith David Laserscanner.
Positionned, setting units and size in blender.
Making 2 parts and making hollow in 3Dcoat.
Rendered in blender.
Printed at shapeways 7cm.
Making mold and silver casting in india.
Attachments
Snuffbox.jpg
User avatar
MarcelB
 
Posts: 12
Joined: Sat May 12, 2012 1:31 pm

Re: Snuffbox scanned whith David

Postby drndadoo » Mon Nov 30, 2015 1:37 pm

Nicely done. Can you tell us your setup please (cam. projector and so...)?
drndadoo
DAVID Support
 
Posts: 194
Joined: Tue Mar 24, 2015 3:09 pm

Re: Snuffbox scanned whith David

Postby MarcelB » Sun Jan 10, 2016 7:52 pm

No special set up
I just used the scanner "out of the box" whith the simple webcam.
I made calibrations as required from the software..
User avatar
MarcelB
 
Posts: 12
Joined: Sat May 12, 2012 1:31 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests