Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Snuffbox scanned whith David

Anything that doesn't fit the other topics should go here.

Snuffbox scanned whith David

Postby MarcelB » Fri Nov 27, 2015 7:48 pm

Original lezard, 30 cm in one piece pottery, was scanned whith David Laserscanner.
Positionned, setting units and size in blender.
Making 2 parts and making hollow in 3Dcoat.
Rendered in blender.
Printed at shapeways 7cm.
Making mold and silver casting in india.
Attachments
Snuffbox.jpg
User avatar
MarcelB
 
Posts: 12
Joined: Sat May 12, 2012 1:31 pm

Re: Snuffbox scanned whith David

Postby drndadoo » Mon Nov 30, 2015 1:37 pm

Nicely done. Can you tell us your setup please (cam. projector and so...)?
drndadoo
DAVID Support
 
Posts: 194
Joined: Tue Mar 24, 2015 3:09 pm

Re: Snuffbox scanned whith David

Postby MarcelB » Sun Jan 10, 2016 7:52 pm

No special set up
I just used the scanner "out of the box" whith the simple webcam.
I made calibrations as required from the software..
User avatar
MarcelB
 
Posts: 12
Joined: Sat May 12, 2012 1:31 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests

cron