Hello,
Is there any CAD of the SLS-2 available?
Ideally I would need the ruler, camera assembly and projector assembly as different parts.
Any format will suit me, CATIA, SolidWorks, STL, IGS, PLY, OBJ....
Bye
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by the end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
CAD of SLS-2
1 post
• Page 1 of 1
CAD of SLS-2
by Victor.Lamoine » Tue May 12, 2015 10:58 am
- Victor.Lamoine
- Posts: 67
- Joined: Fri Feb 11, 2011 2:29 pm
- Location: France
1 post
• Page 1 of 1
Return to Laser and Camera Hardware
Who is online
Users browsing this forum: No registered users and 1 guest