Hi,
using David 5.0.5.1377 on Win10 x64.
I scanned an object today where I started with capturing textures. After the first scans I turned textures off and continued scanning. Alignment all went fine. But each time I tried to fuse the result, David crashed when the progress bar was almost finished. I restarted and tried 2 more times. Only after I deleted textures from those first scans, Fusion finished successfully.
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
Fusing crashes if there are some textures
1 post
• Page 1 of 1
Fusing crashes if there are some textures
by avogra » Tue Sep 20, 2016 9:50 pm
Projector: Acer K11 with Achromat f=400mm | Cameras: 2x Logitech 9000 Pro with custom C-Mount body | Lenses: 1x Computar M1214-MP, 1x Computar M5018-MP, 1x Schneider-Kreuznach Cinegon CNG 1.4/12
- avogra
- Posts: 23
- Joined: Sat Apr 30, 2016 1:50 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests