On David 4.4.1.720, the Orientation selection will revert to Vertical after calibration of the scanner. I was wondering if there would be a way to save default settings like this. It will save between scans but not between calibrations
Core 2 Duo
4 Gb DDR2
Windows 7 Enterprise
.NET 4.5
David SLS-3
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
Pattern Parameters-Orientation Not Saved
1 post
• Page 1 of 1
Pattern Parameters-Orientation Not Saved
by r3d » Sat Apr 09, 2016 1:33 am
- r3d
- Posts: 1
- Joined: Fri Mar 25, 2016 5:03 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest