Hi,
I would like the ability to set the pivot of a fused mesh to the center of its bounding box and then set that pivot to the world origin for export to other editing programs.
Greg
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
Center pivot and Wolrd Origin
3 posts
• Page 1 of 1
Center pivot and Wolrd Origin
by Bongobat » Sat Oct 19, 2013 5:35 pm
DealExtreme red line laser, Microsoft Lifecam HD-5000
-
Bongobat - Moderator
- Posts: 1002
- Joined: Mon Apr 02, 2007 10:02 am
- Location: Ohio, USA
Re: Center pivot and Wolrd Origin
by TheChosenOne » Sun Oct 20, 2013 10:34 am
In the "Shape Fusion" manually orient the coordinate system and define the axis of rotation. 
-
TheChosenOne - Posts: 47
- Joined: Sun May 01, 2011 7:47 pm
- Location: Ukraine
Re: Center pivot and Wolrd Origin
by ThomasSc » Thu Mar 05, 2015 10:03 am
- ThomasSc
- Posts: 11
- Joined: Thu Nov 27, 2014 11:43 am
- Location: Arnschwang, Bavaria
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest