Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

External Coordinates

You can post your wishes for new features in future program versions here.

External Coordinates

Postby ar_kid » Fri Jan 20, 2012 7:28 pm

I have a basic Microscribe which is handy for measuring but thinking a fixed laser and camera mounted around the tip, similar to the Microscan, would make it a very portable scanner. I have managed an interface in visual basic and can retrieve xyz and roll, pitch, yaw so I'd be using the laser set-up as a 2D profile and off-setting that against the xyz coords of the tip.

Would there be a way to use these values as an input to David?
ar_kid
 
Posts: 28
Joined: Tue Jan 03, 2012 11:18 am
Location: NWUK

Return to Feature Wish List

Who is online

Users browsing this forum: No registered users and 1 guest