Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Problem with hardware, phisical damage maybe

Questions, problems, comments and tips regarding the 3d scanning process.

Problem with hardware, phisical damage maybe

Postby mishodar » Sat Jun 18, 2016 4:54 am

Hi,

I've sls 2 scanner and it worked fine for my work. The problem is, last week it was taken to the field for scanning and after returning it began to show heavy problems. Probably someone dropped it. Or it was damaged during transporting without care. At first look everything works fine, the projector lights well and the calibration is made as it should, but after catching the mesh, it just shows the bunch of chaotic points. Sometimes it gives very very noisy scan where you can hardly find the shapes. What can I do to find the problem or should I send it to reseller? Please help me, this hardware was very important in my researches and all my works are stopped. Thank you

Michael
mishodar
 
Posts: 1
Joined: Mon Jan 06, 2014 8:33 pm

Re: Problem with hardware, phisical damage maybe

Postby hal » Wed Jul 27, 2016 10:33 am

Hello dear Michael,

that sounds strange: if calibration si correctly performed, it is strange that the hardware have some problems.
If the light of the projector is ok, that is the same for the lens? the focus wheel works correctly? the optics of the camera looks ok? camera focusing is as usual?

Can you share the calibrations screenshot and the scan result screenshot? Thanks.
Mattia
User avatar
hal
Moderator
 
Posts: 1527
Joined: Thu Mar 01, 2007 4:08 pm
Location: Cavaria con Premezzo (VA), Italy.


Return to 3D Laser Scanning

Who is online

Users browsing this forum: No registered users and 3 guests