Hi All,
I'm very new here and in DAVID world.
I'm thinking to buy the DAVID SLS-2 for scanning vehicles (mainly vans) in order to design adaptations as a mobile offices.
I have experience with Sketchup Pro 2015, so my question is if someone of you know the most proper workflow for managing point cloud generated for DAVID on Sketchup, or should be better to manage them in another 3D software, or with a point cloud software between DAVID and Sketchup?.
The idea is to measure and adapt the sketchup designs to the vehicle shapes, and then to cut the pieces on CNC.
Please i'll appreciate any orientation about this subject.
Best regards,
Irving Williamson G.
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
POINT CLOUDS TO SKETCHUP
2 posts
• Page 1 of 1
POINT CLOUDS TO SKETCHUP
by Irving Williamson » Mon Oct 19, 2015 6:29 pm
- Irving Williamson
- Posts: 1
- Joined: Fri Oct 02, 2015 6:09 pm
Re: POINT CLOUDS TO SKETCHUP
by drndadoo » Tue Oct 20, 2015 9:37 am
- drndadoo
- DAVID Support
- Posts: 194
- Joined: Tue Mar 24, 2015 3:09 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest