Dear DAVID Community,

As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.

To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums

Align ???!!

Questions, problems, comments and tips regarding the 3d scanning process.

Align ???!!

Postby Iliotério » Tue Dec 16, 2014 2:17 pm

Hello guys,

After making the total scan, I note that the last scan does not fit with the first, already tried with other pieces, but the result is always the same.
Always do Align to previews scan..

Can anyone help me?

Thanks. :wink:
Posts: 5
Joined: Mon Dec 01, 2014 1:55 pm

Re: Align ???!!

Postby JDM Dyno » Tue Dec 16, 2014 4:07 pm

have you tried fine pairwise alignment on each pair after your free alignment you may have small errors that add up to a big one at the end or try aligning again in reverse order, some times works out better,

I normally hide all the scans except the ones I'm working with in fine alignment, if it does not look right try contact pairs then fine alignment then global to finish

as it looks like you have a turntable if you know the degrees then try around Y axis rotation angle,

hope that helps

p.s I would try a bigger angle than 10° on your camera David recommend 22°
david sls2.jpg
Camera's: 2 x DFK 42BUC03 Duel Camera,
c615 modified with Computar megapixel lens
lenses: 2 x Pentax 12mm, 2 x Computar 8mm
Optoma ML300 Projector
User avatar
JDM Dyno
Posts: 185
Joined: Sat May 10, 2014 9:32 pm
Location: England

Re: Align ???!!

Postby Iliotério » Tue Dec 16, 2014 4:53 pm

Ok, tks i will try..
Posts: 5
Joined: Mon Dec 01, 2014 1:55 pm

Return to 3D Laser Scanning

Who is online

Users browsing this forum: No registered users and 2 guests