http://lesagegp.wordpress.com/2013/11/03/3d-laser-scanner/
Interestingly, two laser lines are used for the calibration. I think this could be used as the white light is the principle.
Tibor
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
Laser line calkulation
1 post
• Page 1 of 1
Laser line calkulation
by hunkatibor2 » Thu Dec 26, 2013 1:18 pm
Hi
http://lesagegp.wordpress.com/2013/11/03/3d-laser-scanner/
Interestingly, two laser lines are used for the calibration. I think this could be used as the white light is the principle.
Tibor
http://lesagegp.wordpress.com/2013/11/03/3d-laser-scanner/
Interestingly, two laser lines are used for the calibration. I think this could be used as the white light is the principle.
Tibor
Intel Xeon E5410 2.33GHZ 16GB RAM Windows 7 64bit David 4.5.0
2 Basler A622F camera 2 Tamron Asfirical AF 28-80mm lense
LG DLP Projector PF1500G Canon D40 Tokina 17-70mm 1:2.8-4,5
Humanti Calibration panel system and Alignmed&Two camera
2 Basler A622F camera 2 Tamron Asfirical AF 28-80mm lense
LG DLP Projector PF1500G Canon D40 Tokina 17-70mm 1:2.8-4,5
Humanti Calibration panel system and Alignmed&Two camera
- hunkatibor2
- Posts: 1408
- Joined: Tue Mar 16, 2010 4:26 pm
- Location: Hungary
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest