Dear DAVID Community,

As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.

To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums

Dental Cast Scan

Questions, problems, comments and tips regarding the 3d scanning process.

Dental Cast Scan

Postby eliscio » Mon Dec 06, 2010 2:56 pm

Hello All,

Here is a sample that I did the other night. I had to use about 12 scans to get everything referenced properly in shapefusion, but I did not use all scans for the final version (some were only to get the orientation).

This was done with manual hand scanning and a SPC9000 webcam. The new calibration panels are excellent and give you a lot of flexibility.

I saw some other people here scanned dental casts to and it seems they had a bit better results, perhaps with a bit more detail. This might be to having an automated setup or at least a mechanized motor to drive the laser slowly which seems to be the key for clean scans.

Any comments welcome.

User avatar
Posts: 230
Joined: Sat Mar 14, 2009 2:05 am

Postby hal » Mon Dec 06, 2010 9:59 pm

Hi eliscio,

Cool scans! I think that you have pushed the webcam at its limits.
For my point of view is great: enough detailed and very precise. And so smooth.

Keep up your great work!

User avatar
Posts: 1527
Joined: Thu Mar 01, 2007 4:08 pm
Location: Cavaria con Premezzo (VA), Italy.

Return to 3D Laser Scanning

Who is online

Users browsing this forum: No registered users and 1 guest