Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

How to prepare an object for scanning

Questions, problems, comments and tips regarding the 3d scanning process.

Re: How to prepare an object for scanning

Postby ferret7 » Mon Nov 12, 2012 1:29 am

Re: Hints for reflective objects

Postby ferret7 » Sat Jun 23, 2012 9:40 pm
If you are in the US - Magnaflux Spotcheck SKD S2 Developer is the "standard" that all the 3D Scanning studios use.
It is an ultra fine white powder that goes on wet and drys almost instantly and washes of easily with warm soapy water.
Note: there are a "few" caveats ...
extremely high VOC content - spray OUTSIDE or in well ventilated room or you will pass-out !
It will craze/crack some paints and plastics so do a pre-test on a hidden surface BEFORE going on an all out spraying spree ...

http://www.zip-bit.com/whitening-spray-p-9-l-en.html
or
http://www.markingpendepot.com/skds2spo ... rosol.aspx (these are the folks I get it from)

Best regards,
-jay-
NextComputing Radius EX-B, Quad Core, 32GB DDR3, Dual Quadro 6000, Quadro 400, UniBrain FireBoard800-e™ Pro Dual - Creaform GO!SCAN3D, 3D3 Solutions HDI ADVANCE R2 - DAVID Vision Systems US (importer/reseller)
User avatar
ferret7
 
Posts: 24
Joined: Sat Sep 25, 2010 5:39 am
Location: San Jose, CA, U.S.A.

Previous

Return to 3D Laser Scanning

Who is online

Users browsing this forum: No registered users and 2 guests

cron