Page 1 of 1

3d alignment

PostPosted: Thu Nov 05, 2015 7:51 pm
by dental_art
not possible to add an alignment
software would be very helpful

Re: 3d alignment

PostPosted: Fri Nov 06, 2015 9:27 am
by drndadoo
Hi dental_art,

can you post a picture or upload a david project so we can see what is it about?

Re: 3d alignment

PostPosted: Fri Nov 06, 2015 11:35 am
by dental_art
in NextEngine ScanStudio and you can align the object after fusion in very handy if you create david

Re: 3d alignment

PostPosted: Fri Nov 06, 2015 11:42 am
by dental_art
I include photos
Comparison between laser scanning
and scanning david
work 100/100

Re: 3d alignment

PostPosted: Mon Nov 09, 2015 11:16 am
by drndadoo
If I understand you good, you want a new feature, that after a fusion you can set initial position for the object?
So next time you load the project the object is in initial position.

Re: 3d alignment

PostPosted: Tue Nov 10, 2015 9:38 am
by dental_art
import obj stl etc. Cam software and find it comfortable lined up ready to mill or print without going through CAD software to align the axes xyz

Re: 3d alignment

PostPosted: Tue Nov 10, 2015 10:07 am
by drndadoo
OK, I hope that development team will take this into consideration.

Re: 3d alignment

PostPosted: Sat Jan 09, 2016 2:09 am
by robssm
yes please! Or, how about just tell us how the origin is determined in David and we can perhaps work around it? is it the first scan? the last scan? What determines this?

Re: 3d alignment

PostPosted: Mon Jan 11, 2016 12:12 pm
by drndadoo
The calibration corner is 0 value, left panel is Z axis and right one is X axis. Under Settings > Advanced settings > HardwareSetup there are Left and Right Calibration Panels and
you can rotate them rot_x, rot_y, rot_z. If you know the the angle value btw. your object and left Panel then you can rotate your coordinate system so that an object is alligned with
the x,y,z axes. I hope I wrote this one correctly, if I am not then someone please revise this :)