Well, I've got about 7 hours in this scan so far and have little more than a muddy misaligned model. I've tried powder, no powder, upside down, right side up, standing on end, laying flat and everything in between.
I've tried all kinds of alignment attempts, global, contact pair, manual, 120mm panel 240 panel and so far I can't get a good clean model. The first 3 - 5 scan look great, very clean and detailed, perfectly aligned. The more scans I add the worse it gets and the more alignment problems I have.
Can it really be this hard? I'm mean I've had great scans in the past but this blue gun is kicking my ass! It's for a customer too.
Acer Aspire V15 laptop w/ 8g ram / Windows 10, Acer K132, DFK 42BUC03, Computar Megapixel 2/3 12mm, David 4.0, V-Slot 1000x20x40 linear rail, Cam and Projector mounts by JDM Dyno.