I am just wondering how these setting effect the scan and then the fusion.. I have played around with them but was wondering if there was a good guideline for there purpose..
What is the optimal setting?
Does it effect the fusion ?
Thanks
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
Smooth Average, medium, Quality check
1 post
• Page 1 of 1
Smooth Average, medium, Quality check
by everettc4 » Thu Jul 04, 2013 4:18 pm
- everettc4
- Posts: 18
- Joined: Wed Mar 21, 2012 7:30 am
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest