Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Precise Alignment

The place for all topics related to the 'Shapefusion' tool of DAVID.

Precise Alignment

Postby benoy » Tue Jan 17, 2012 4:41 am

Hi All,

I sorry for reposting. I was unable to attach my diagrams in the earlier post.
Please see the diagrams. The first one is the shape of the object scanned. It is U shaped. It is about 8 Cm in lenth and width and about 2.3 Cm in height.

The next 2 pictures show the assembly from top and side. Now I Will come to my problem.
I keep my turn table at an angle to the Camera Projector assembly to get the depth of the object scanned. I get beautiful scans. But when I try to align them one side aligns well but the other side shows a slight mal-alignment. I repeatedly get this. I tried angle based alignment I also tried to align in Geomagicwrap but again I am getting the same result. I think it is because of the change in distance between point A to camera and that of Point B to the Camera. How can I over come this limitation? I need help from the forum.

Thankyou

Benoy

My projector is LG 301
Camera is Image source FA 301
processor i3
4 Gb Ram
windows 7
Attachments
Approx scan Object shape.gif
Shape of the object scanned
Approx scan Object shape.gif (10.9 KiB) Viewed 1445 times
Scan assembly top view.gif
Cam, Proj, Stepper motor assembly View from top
Scan assembly top view.gif (9.95 KiB) Viewed 1445 times
Scan assembly side view.gif
Assembly view from side
Scan assembly side view.gif (9.54 KiB) Viewed 1445 times
benoy
 
Posts: 143
Joined: Wed Feb 11, 2009 8:03 pm
Location: India

Return to Shape Fusion

Who is online

Users browsing this forum: No registered users and 1 guest

cron