Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

Cannot calibrate large panel with vertical camera

The place for questions, problems, comments and tips regarding the camera calibration.

Cannot calibrate large panel with vertical camera

Postby vchmiele » Mon Aug 15, 2016 10:23 am

I am trying to calibrate a large panel (for full body scanning). Whenever I orientate the camera vertical I get the error "could not find a valid mapping between measured points and model parameters".

When I orientated the camera horizontally, the calibration works. Unfortunately with this orientation I cannot scan full body subjects.

This setup used to work flawlessly in David 3. I am VERY frustrated, I have been troubleshooting all weekend...
Posts: 61
Joined: Mon Feb 21, 2011 11:09 am

Re: Cannot calibrate large panel with vertical camera

Postby drndadoo » Mon Aug 15, 2016 10:54 am

Do you have DAVID 5.0.3 installed? There were some calibration problems in previous versions, so in 5.0.3 they should be fixed.
DAVID Support
Posts: 194
Joined: Tue Mar 24, 2015 3:09 pm

Return to Camera Calibration

Who is online

Users browsing this forum: No registered users and 1 guest