Hi everyone,
I am looking for some confirmation on the calibration data. I would like to know which are the different variables given in the projector file, provided by the calibration. Then, I would like to know also in which coordinate frame the pose of the camera is given.
Thanks in advance,
DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.
To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.
Projector file content
4 posts
• Page 1 of 1
Projector file content
by Noefrat » Thu Jun 16, 2016 10:43 pm
- Noefrat
- Posts: 13
- Joined: Thu Jun 16, 2016 2:12 pm
Re: Projector file content
by drndadoo » Tue Jul 05, 2016 9:32 am
Maybe this helps:
http://wiki.david-3d.com/calibration
http://wiki.david-3d.com/calibration
- drndadoo
- DAVID Support
- Posts: 194
- Joined: Tue Mar 24, 2015 3:09 pm
Re: Projector file content
by Noefrat » Mon Aug 29, 2016 3:12 pm
Thank you for your reply!
Actually, I needed this information to work on stereo ground truth dataset ().
Actually, I needed this information to work on stereo ground truth dataset ().
- Noefrat
- Posts: 13
- Joined: Thu Jun 16, 2016 2:12 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest