DAVID-Laserscanner Forum
Incredibly Low-Cost 3D Scanner for Everyone...
Dear DAVID Community,
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
As you are probably aware, the entire DAVID company, team and product range has been integrated into HP Inc.
This forum is now read-only. Relevant content has been migrated to HP and merged into HP's Support Forums on November 1, 2016.
To start new discussions for 3D Scanning, please register and post your new topic at the HP Support Forums
What is the maximum degrees error?
2 posts
• Page 1 of 1
What is the maximum degrees error?
by tailele » Sat Mar 05, 2016 8:46 pm
Hi , i scan my first calibration panel. My hardware is in my firm... Now when I scan the calibration panel after the calibration ( naturally ) I load it on geomagic and then I try to misure the angle... I see that my angle is 89,956 degrees..so I have done a calibration panel with a error of 1/2 decim of degrees . Could it be acceptable or i probably have some error when I ll try fuse a scan?
Benq w700, hp elitebook 8570w; blackmagic intense shuttle 3.0; nikon D600; Nikon macro 105mm VRII
- tailele
- Posts: 25
- Joined: Sat Apr 25, 2009 2:55 pm
Re: What is the maximum degrees error?
by drndadoo » Mon Mar 07, 2016 8:49 am
In calibration process this small errors are compensated. Alignment function should work good for you.
- drndadoo
- DAVID Support
- Posts: 194
- Joined: Tue Mar 24, 2015 3:09 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest