Dear DAVID Community,

In 2016, DAVID and this forum have been integrated into HP Inc.
This forum has been read-only since then, and will be switched off by then end of 2019.

To everyone who has contributed here, we thank you for all your work and for the constructive, helpful and friendly atmosphere you have created!
Please continue to discuss on the HP Support Forums.

I built a calibration panel today

The place for questions, problems, comments and tips regarding the camera calibration.

I built a calibration panel today

Postby glidergider » Mon Dec 05, 2011 6:31 am

Using my CNC machine, I was able to route the calibration panels. The height is about 23 inches. I'm happy with the build, and it calibrated pretty easily. However, when I shine the laser into it, there is a significant reflection. I cut it from per-finished white board that is shinier then I anticipated. Initial testing was poor, maybe because of the shiny nature of the calibration backdrop.

Here's a picture.
2011-12-04 19.03.17.jpg
Posts: 3
Joined: Thu Dec 01, 2011 9:18 pm

Return to Camera Calibration

Who is online

Users browsing this forum: No registered users and 1 guest